Simple Arduino + LED Tutorial
1) Get the LED, and plug it in to your Arduino. Plug in the long end to pin 13, plug the short end to the GND.
2) Plug in the Arduino into your laptop. Go to Tools->Serial Port. Choose the USB port that appears.
3) Take the code from the BlinkingLED tutorial and paste it in to the arduino like so:
4) Hit File->Upload to I/O Board.
5) Hit (physically) the little reset button. Voila! a blinking LED!
Tagged as: arduino
Published on July 1, 2009
For this you'll need: an Arduino, an LED, a USB cable, and the Arduino software.
1) Get the LED, and plug it in to your Arduino. Plug in the long end to pin 13, plug the short end to the GND.2) Plug in the Arduino into your laptop. Go to Tools->Serial Port. Choose the USB port that appears.
3) Take the code from the BlinkingLED tutorial and paste it in to the arduino like so:
4) Hit File->Upload to I/O Board.
5) Hit (physically) the little reset button. Voila! a blinking LED!
Tagged as: arduino
Comments are currently closed for this entry.
About This Page
This entry is from my tutorial section and was written on July 1, 2009. It's been tagged with arduino. There have been 0 comments so far.
Via Twitter
Just got back from Japan and found a truck hit my car. No note, but my neighbor wrote down their rego. (about 5 days, 4 hours ago)
Related Readings
